Banner DXM1200-X2, Инструкция по эксплуатации

Страница: 15 / 83

February 02, 2024
DXM1200-X2 Controller Instruction Manual
© Banner Engineering Corp. All rights reserved.
15
Overview of the DXM Configuration Software features
Internal Micro
USB
Ethernet
DXM Configuration Software
Local Registers
Register
View Utility
System
Settings
Register Mapping
Scheduler
Action Rules
ScriptBasic
XML Config File
The DXM Configuration Software configures the DXM Controller by
creating an XML file that is transferred to the DXM Controller using
an Ethernet connector or the internal micro USB connection. The
DXM Controller can also receive the XML configuration file from a
Web server using a cellular or Ethernet connection, depending on
your model.
This configuration file governs all aspects of the DXM Controller
operation.
The DXM Configuration Software allows the user to define
parameters for the Controller and then saves the configuration in
an XML file on the PC. After the configuration file is saved, upload
the XML configuration file to the Controller for operation.
The wireless network devices are a separate configurable system.
Use the DX80 User Configuration Software to configure the internal
DX80 wireless Gateway and the attached wireless Nodes. Use the
MultiHop Configuration Software if the internal radio is a MultiHop
device.
All tools can be connected to the DXM Controller using an Ethernet
connection or the internal micro USB.
Configuring the DXM1200-X2 Controller
This section walks you through setting up the DXM Configuration Software and communicating with a connected DXM
device. Version 4 of the DXM Configuration Software supports multiple DXM device models, each of which incorporates
different features.
After a DXM model is connected to your computer, the software automatically detects the correct model and loads the
appropriate screens. You may also manually select which model of DXM you are configuring if you intend to create a
configuration file without first connecting a device. This ensures that the interface and the configuration file use the correct
features.
Not all screens are available for all models. To change to another model of DXM, go to the Select Mode screen and use the
drop-down list to select another model. If the active configuration is incompatible with the selected model, you will be
prompted to either proceed and wipe out the active configuration or cancel the model change and preserve the configuration.
Connect the DXM1200 to the Software
Follow these steps to connect your DXM1200 to the software and download the existing configuration file.
On the computer, download the DXM Configuration Software v4 from the Banner Engineering website and install it. 1.
On the DXM: Apply power to the DXM. 2.
Connect the DXM Controller to the computer with an M12 to RJ-45 cable or skip if the DXM is connected to the same
network as the computer. 3.
On the computer: Launch the DXM Configuration Software. 4.
From the Connect to DXM menu, use the Select DXM Model drop-down list to select your controller model. 5.