Banner DF-G2 High Speed Expert, Быстрый старт

Страница: 6 / 9

Factory Default Settings:
Setting Factory Default
Threshold 3700 (typical)
TEACH Selection Window SET
Response Speed Standard: 250 µs
Offset Percent 2%
Totalizer Counts OFF
Totalizer One-Shot OFF
Dynamic Event Stretcher 50%
Display Readout Numeric, ECO disabled, Normal Orientation
Adjust Mode
Sliding the RUN/PRG/ADJ mode switch to the ADJ position allows the user to perform Expert TEACH/SET methods.
TEACH Procedures
The instruction manual has detailed instructions for these TEACH modes:
• Window SET
• Light SET
• Dynamic TEACH
Window SET
• Sets window thresholds that extend a programmable % offset above and below the presented condition
• All other conditions (lighter or darker) cause the output to change state
• Recommended for applications where a product may not always appear in the same place, or when other signals
may appear
• See Program Mode in the user's manual for programming the Offset Percent setting (to increase/decrease the
window size)
A single sensing condition is presented, and the sensor positions window thresholds a programmable % offset above and
below the presented condition. In LO mode, Window SET designates a sensing window with the Output ON condition inside
the window, and the Output OFF conditions outside the window.
Sensor positions
window thresholds
a programmable %
offset from the
presented condition
Darkest
(no signal)
Most Light
(saturated
signal)
Condition
Presented
Sensing Window
Output OFF Output OFF Output ON
Figure 3. Window SET (Light Operate shown)
Output ON and OFF conditions can be reversed using the LO/DO switch.
Light SET
• Sets a threshold a programmable % offset below the presented condition
• Changes output state on any condition darker than the threshold condition
• Recommended for applications where only one condition is known, for example a stable light background with
varying darker targets
• See Program Mode on page 5 for programming the Offset Percent setting
DF-G2 High Speed Expert
™
Dual Display Small Object Counter
6 www.bannerengineering.com - Tel: +1-763-544-3164 P/N 178061 Rev. E