7. Using the alignment mark as a reference, mark on the disc where the front of the Q45VA is.
This marks where the Q45VA is going to face after you have glued the disc to the mounting surface.
8. Remove the disk from the base plate.
9. Apply Loctite 330 and 7387 Activator (or similar adhesive) per instructions to the spiraled surface side of the disc and place
on the chosen surface so the marked section is in line with the shaft of the motor.
The front of the device should be facing the correct direction and the x-axis of the sensor is aligned with the shaft after the
Q45VA is mounted to the disc.
10. After the recommended adhesive that mounts the disc to its mounting surface has dried, apply Loctite to the set screw.
11. Screw the Q45VA back onto the disc.
Q45VA Bracket Assembly Quick Start Guide
©
Banner Engineering Corp. All rights reserved
