Set up BeoVision 4 and BeoSystem 2
We recommend that you follow the
procedure described below when you
set up BeoVision 4:
– Unpack the system and the screen.
– Consider the appropriate
surroundings. Guidelines are
included on this page.
– Mount the wall bracket as
described in the Guide enclosed
with the wall bracket.
– Connect the screen.
– Mount the IR receiver.
– Connect speakers and additional
equipment, as described on the
following pages.
Do not connect your system to the
mains until you have connected your
screen, loudspeakers and other
equipment!
For further information about the
close-up socket panel on BeoSystem 2,
refer to the chapter ‘
Close-up socket
panel on BeoSystem 2’
on page 12.
Before you start…
– Make sure that your products are set up,
placed and connected in accordance with
this Guide.
– Do not place any items on top of
BeoSystem 2 or the screen.
– Your products are developed for indoor
use in dry, domestic environments only,
and for use within a temperature range of
10–40ºC (50–105ºF).
– Do not attempt to open your products.
Leave such operations to qualified service
personnel.
BeoSystem 2:
– Place BeoSystem 2 in the Cabinet. If you do
not wish to use the Cabinet, make sure that
there is sufficient space around BeoSystem 2
for ventilation.
– Always place BeoSystem 2 on a firm and
stable surface.
The plasma screen:
– Due to the weight of the screen, any
moving or lifting of the screen should be
done by two persons.
– When lifting the screen, grip the top and
bottom edges.
– Carry the screen in such a way that it is in
an upright position at all times.
– If you must put the screen down at any
time prior to placing it, we recommend
that you rest it in an upright position on its
bottom edge on a stable, flat surface.
The
screen is not designed to stand on its own.
It must be supported until mounted on the
wall bracket!
– The picture can be distorted at altitudes
where the air pressure is lower than 833 hPa
(approximately 1500 metres or higher).
– When mounting the screen in the wall
bracket, leave a space of about 10
centimetres at the top, bottom and sides.
4
Place BeoSystem 2 in the Cabinet. When
connections are complete, attach the back cover
with the four screws included with the Cabinet.
Содержание BeoVision 4
Страница 1: ...Reference book BeoVision 4...
Страница 25: ...25...
Страница 44: ...www bang olufsen com...