Software update 35
Automatic software update
Is per default (factory reset) set to On and can be set to Off (not recommended).
If set to On and BeoSound Shape is in standby mode, a check for new updates are made every night (local time) somewhere between T00:00 and
T06:00.
During software update the BeoSound Core will be updated first. The LED on the Core will flash red. When the Core has been updated, the
amplifiers will, in a setup with 3 amplifiers, be updated in the following sequence :
- First the master amplifier A (the amplifier connected to the BeoSound Core) will flash red for a few seconds, and then it will become solid white,
for a couple of seconds. Then the light will turn off.
- Then the slave amplifier C will flash red for a few seconds, and then it will become solid magenta, for a couple of seconds. Then the light will turn
off.
- Finally, the slave amplifier B will flash red for a few seconds, and then it will become solid magenta, for a couple of seconds. Then the light will
turn off.
(Note: White colour means that the amplifier is the master amplifier, i.e. connected to the BeoSound Core. Magenta colour means that the
amplifier is configured as a slave amplifier)
In the following setups, it may be relevant to set automatic update to Off: Hotels, stores, home automation and test environments, as if an update
takes place either in BeoSound Shape or in another Network Link product, all other Network Link products will then ask if they should also be
updated. This may be unlikely in certain situations. If automatic SW update is set to Off, then check for updates regularly, when ready to take
updates.
