![background image](http://html1.mh-extra.com/html/bang-and-olufsen/beoplay-v1-40/beoplay-v1-40_service-manual_3763597019.webp)
LED indications 3.3
BeoPlay V1 does not start up
To determine wether the PCB01, Video Engine is defective or not, it is possible to
disconnect all other module from PCB01, Video Engine, except PCB04, Power
Supply and then connect PCB01, Video engine to ServiceTool.
PCB04, Power Supply must be working correctly. (Check 5V and 12V).
Disconnect one, more or all modules connected to PCB01, Video Engine:
- P101 (PCB58, IR Receiver & Room Awareness)
- P142 (NTC)
- P130 and P131 (PCB35, ICEpower Amplifier)
- P116 (PCB49, Backlight Driver)
- P120 and P121 (LCD)
If all plugs are disconnected (except for P103 from PCB04, Power Supply) and
PCB01, Video Engine is OK, ServiceTool is able to connect to PCB01, Video Engine
via RJ45 plug as described here:
- Connect the TV to the mains and after 10 seconds ‘Local Area Connection (-)
down’ changes to ‘Local Area Connection (169.254.xxx)-up’ in ServiceTool.
- Wait 25 seconds for Video Engine to complete the start-up and click ‘Connect’.
(If you try to connect sooner, the connection fails, and you have to reconnect).
- Video Engine is now ‘awake’ for about 90 seconds where connection/read out
from System info is possible before Video Engine automatically cuts the
connection to ServiceTool.
To make a new connection, first disconnect from the mains for 40 seconds.
LED indications
LED indications
Indication
Green
Red
No errors - no timers programmed
Off
Off
Overheating (red/green LEDs are alternating)
approx. 6
blinkings per 10 sec.
approx. 6
blinkings per 10 sec.
TV is cooling down in Standby (after overheating)
ON
Theft protection ON, product has been disconnected from
mains for too long. Pin code required to switch ON the
product
approx. 6
blinkings per 10 sec.
Theft protection ON, PIN-code entry locked (not possible)
due to too many failed PIN attempts
approx. 13
blinkings per 10 sec.
SW fetched from portal. Product should not be
disconnected from mains
On
SW being burned into FLASH. Product should not be
disconnected from mains
Blinking 2 times
followed by ...
...
approx. 6
blinkings per 10 sec.
until completed
Product is ON but no picture
On
Option programming the producat
300 ms
Press Standby on remote control to verify that the product
is connected to mains
1 s
Содержание BeoPlay V1-40
