Bang & Olufsen BeoMedia 1, Руководство по установке

Страница: 8 / 24

BeoMedia 1 Installation Guide
Page 7
BeoVision US Model
Video
Connect the VGA output on BeoMedia 1 to the VGA input on the BeoVision.
Connect the S.Video and CVBS plugs to the output socket on BeoMedia 1, and to the input sockets on the BeoVision
Audio:
Connect the mini jack cable to the audio socket on BeoMedia 1. Connect the mini jack/phono cable to the L-R sockets
on the BeoVision (red to R and white to L).
Network:
Do not connect the network cable or fit any wireless PCMCIA network card until BeoMedia 1 has
been configured and tested in stand-alone mode.
5. Setting up the TV
Now the input on the TV to which BeoMedia 1 is connected must be configured. Switch on the TV and press <MENU>
on Beo4 to activate the Setup menu.
Select <SETUP> or <OPTIONS> and <CONNECTIONS> to define the AV input to which BeoMedia 1 is connected. If the
TV is equipped with application software that supports full BeoMedia 1 functionality, you have the possibility to select
PC. Otherwise select V.AUX. If the TV SCART can be accessed by choosing V.TAPE2 this can be used as an alternative to
V.AUX. This solution is only chosen if the V.AUX command is already used. Throughout this document V.AUX will be
used in the different descriptions – it can be substituted by V.TAPE2 whenever.
Note: As from 6 December 2004 only BeoVision 7-32/40 and TVs with the S2 chassis that have
software version 15.10 or higher provide full support for BeoMedia 1. Use the service menu <0>
<0> <GO> and MONITOR INFO to see the current software version.