BeoMedia 1 Installation Guide
Page 19
When using wireless connection
In this setup the customer’s home network needs to be selected.
On the tab Wireless Networks, adjust necessary settings such as adding preferred networks and change properties (SSID
and WEP key) on the desired network.
Note: Network Key. It is very important to get this key from the customer. It is later in this document referred
to as WLAN KEY. It is important, that this key is typed in the “Network settings” – “WLAN Key”
(This is described on the next page).
Note: BeoMedia 1 supports recovery of following Network Authentication in WLAN: Open, Shared, WPA-PSK.
If data encryption is WEP, the Key index must be set to 1. Changes made under the tabs “Authentication”
and “Connection” are not available after “Recovery”.
Finish network setup
Test the network connection by starting Internet Explorer on the desktop, and then test that there is an internet
connection by entering a website address, for example www.bang-olufsen.com. Verify that the requested page occurs
and exit to BeoMedia 1 main menu by pressing <EXIT> on Beo4.
Note: The N. RADIO source is still not working at this point since the necessary user
registration has to be performed first.
Check for updates
The next step is to make sure that BeoMedia 1 has the newest software available. Go to the following steps:
1.
Go to BeoMedia 1 main menu (press PC or V.AUX on Beo4) and press the red button on Beo4
2.
Select <9> for entering the configuration menu
3.
Select Maintenance and then go to Software version
4.
Press <GO> to look for new software update - If a new software version is available press <GO> to start
update.
Содержание BeoMedia 1
Страница 1: ...BeoMedia 1 Installation Guide English ...