Fault flow chart 2.
Select e.g. Radio or
CD on the
Audiomaster, and
press GO on Beo4
Does BeoLab 9 turn
on (Green light in
LED)
Confirm 5V on PCB4,
Power Supply P14 pin
7
Check Power Link
cable and
Audiomaster.
Reconnect/replace if
nescessarry.
(This is not covered in
this fault flow chart)
Confirm -12V on
PCB4, Power Supply
P14 pin
Replace PCB4, Power
Supply
Replace PCB4, Power
Supply
No
Yes
Confirm 44V on PCB4,
Power Supply P15
pin 4
Replace PCB4, Power
Supply
Confirm -44V on
PCB4, Power Supply
P15 pin 5
Go to
next page
Confirm 12V on
PCB4, Power Supply
P14 pin 5
Replace PCB4, Power
Supply
Confirm 66V on
PCB4, Power Supply
P15 pin 6
Replace PCB4, Power
Supply
Confirm approx 4.7V
on PCB4, Power
Supply P14 pin 9
Replace PCB4, Power
Supply
Replace Module 999,
Amplifier
Содержание BeoLab 9 6217
