Bang & Olufsen BeoLab 17, Руководство по обслуживанию, Страница: 24 / 72

3.4 Adjustments
PCB89, Wireless Power Link Rx - when backup function is possible
Backup/Restore
This function is used when PCB89, Wireless Power Link Rx is replaced and it is still
possible to communicate with the old module. The following data is handled:
- ID number
- Serial number
- Type number
- Item number
- Calibration of speaker units
- Calibration of the amplifier
- Product settings
- Wireless data
- A new calibration of the amplifier is performed again.
Connect ServiceTool, launch BeoLab 17 and follow the procedure under
Repair -> Chassis.
Connecting speaker wirelessly
After replacement of PCB89, Wireless Power Link Rx the speaker must be set up in
the wireless system correctly. Depending on the setup, there will be a few settings.
Setup with BeoLab Transmitter 1:
- Press the RESET button on the speaker (set speaker in associate mode)
- Press SELECT and STORE simultaneously between 1.5 and 10 seconds to reset
association on the BeoLab Transmitter 1
- Press SELECT to make a rescan on BeoLab Transmitter 1
Setup with product equipped with Wireless Power Link Tx:
- Press the RESET button on the speaker (set speaker in associate mode)
- Delete speaker in menu of the product equipped with Wireless Power Link Tx
- Perform a rescan in menu of the product equipped with Wireless Power Link Tx