B&R Industries REVERSE OSMOSIS, Руководство пользователя

Страница: 14 / 14

Reverse Osmosis Systems
Model Number:__________________________________________
General Installation/Operation/Maintenance Requirements
™
Do not use with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
™
This reverse osmosis system contains a replaceable treatment component critical for effective reduction
of total dissolved solids. The product water shall be tested periodically to verify that the system is
performing satisfactorily.
™
While testing was performed under standard laboratory conditions, actual performance may vary.
™
See owner’s manual for Manufacturer’s limited warranty.
™
This system has been tested and shown to operate at its calculated recovery rating under standard
test conditions.
™
Chlorine in the influent water may affect the RO membrane polymers.
™
See owner’s manual for complete installation/operation and maintenance requirements, as well as user
responsibility and parts and service availability.
This system has been tested according to NSF/ANSI 58 for reduction of substances listed below. The
concentration of the indicated substances in water entering the system was reduced to a concentration
less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 58.
B&R Industries
1456 W. Scott Ave.
Gilbert, AZ 85233
480-898-0008
*If customer uses a number of full tanks of water per day, this membrane is capable of producing
20-24 gal/day. The higher the pressure is over 50 psi, the more water the unit will produce.
Authorized Dealer ________________________________
Phone __________________________________________
Ave. Ave. Ave. % USEPA
Contaminant Influent Effluent Reduction MCL
Pentavalent Arsenic 290.30 vg/L 6.74 vg/L 98 10 vg/L
Lead 143.6 vg/L 1.91 vg/L 99 10 vg/L
TDS 777.1 ppm 20.24 ppm 98 187 ppm
This system has been tested for the treatment of water containing
Pentavalent arsenic (also known as As(V), As(+5), or arsenate) at
Concentrations of
[
0.050 mg/L or 0.30 mg/L
]
or less. This system
Reduces pentavalent arsenic, but may not remove other forms of
arsenic. This system is to be used on water supplies containing
detectable free chlorine residual at the system inlet or on water
supplies that have been demonstrated to contain only pentavalent
arsenic. Treatment with chloramines (combined chlorine) is not
sufficient to ensure complete conversion of trivalent arsenic to
pentavalent arsenic. Please see the Arsenic Facts section of the
Performance Data Sheet for further information.
Electrical Requirements If applicable
Daily Production Rate 7.5
Efficiency rate* 8.1%
System Weight 25 lbs
System Dimensions 7 x 17 x 15
Max./min. pressure 40-80 psi
Max./min. temperature 40
º
F- 110
º
F
Test parameters: 25º + 1ºC, 50 psi, and pH of 7.5
*Efficiency rating means the percentage of the total water required to operate the system that is treated and available to the user.