Terminal
M1
Position
Signal
1
3
N
EARTH
2
4
L
EARTH
Description
Neutral power supply 230 Vac
Ground connection
Power supply phase 230 Vac
Ground connection
ELECTRICAL CONNECTIONS: TERMINALBOARDS
Flashing light output 230Vac 25W
Motor connection (opening)
Flashing light output 230Vac 25W
Common motor
Motor connection (closing)
M2
5
7
LAMP
OPEN
6
8
9
LAMP
COM
CLOSE
Fixed output to be used for
flashing light with flashing circuit
External accessories 24 Vdc power supply
External accessories power supply. Common Inputs – Outputs
Input GENERAL OPEN (N.O.)
Input GENERAL_CLOSE (N.O.)
Input START (N.O.)
Input PHOTOCELL (N.C.). Active only during closing.
Input SAFETY DEVICES. See DIP 9-10
M3
10
24VDC
11
GND
12
13
14
15
16
G_OP
G_CL
START
PHOTO
SAF
Input ANTENNA SIGNAL
Connector for connexion to the programmer PRG_01
Input ANTENNA BRAID
M4
J3
17
+ ANT
18
- ANT
In the event of an operating fault or failure, cut the power upstream of the control unit and call Technical Service.
Periodically check functioning of the safety devices. Any repairs must be carried out by specialised personnel using
original and certified materials.
The product is not to be used by children or people with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction. Do not intervene on the board for
regulations and/or maintenance.
WARNINGS FOR THE USER
WARNING: IMPORTANT SAFETY INSTRUCTIONS
For people's safety, it is important to follow these instructions.
Please keep this manual.
SR100
10
UK
• Mark the automated gate with visible warning plates.
• Warn the user that children and animals may not play or stand around near the gate.
• Appropriately protect the dangerous points (for example, use a sensitive frame).
