B&G Vulcan Series, Инструкция по эксплуатации

Страница: 38 / 68

Ú
Note:
Sectors are setup relative to the heading line of the radar.
The bearing of the sector is measured from the center line of
the sector.
Ú
Note:
Sector blanking should be applied very carefully to avoid
reducing the radar’s usefulness in identifying valid and
potentially dangerous targets.
Main radar PPI Radar overlay on a chart
Adjust open array park angle
The park angle is the final resting position of the antenna relative to
the heading line of the radar when the radar is set to standby. The
antenna will stop rotating at the desired offset.
Adjust local interference reject
Interference from some onboard sources can interfere with the
Broadband radar. One symptom of this could be a large target on
the screen that remains in the same relative bearing even if the
vessel changes direction.
Halo light
Controls the levels of the Halo Radar blue accent lighting. The
accent lighting can only be adjusted when the radar is in standby
mode.
Ú
Note:
The blue accent pedestal lighting might not be approved
for use in your boating location. Check your local boating
regulations before turning the blue accent lights ON.
38
System setup | Vulcan Series Installation Manual