Screw with slot for ad-
justment
Clamp bearing on ball stud
Bearing cup
Distances the same?
14 / 25
51336-005 en/2022-03
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • [email protected]
2.2.4 Positioning/adjusting the roller carriage
Press the clamp bearing onto the ball stud (clicks in).
Position the roller carriage onto the rim of the ultrasonic bath.
Then check whether it rolls easily on the rim of the bath. If the roller carriage wobbles
or grinds on the rim of the bath, it should be adjusted using the screw (rear left,
outside).
After adjustment, check whether the clamp bearing is on the ball stud and then press
the bearing cup onto the ball stud (clicks in).
2.2.5
Check the coupling opening
Once the ball stud has clicked into place, the sliding rod should be in the centre of the
coupling opening, see image.
If this is not the case, the installation of the mount must be corrected as described in
Sections 2.2.2 and 2.2.3 so that the sliding rod is in the centre and grinding is avoided.
