17
4 Use
Sonication or rinsing always take place directly in the tank. For
this purpose, the objects are placed in a basket and hung inside
the tank which is
fi
lled with bath
fl
uid.
4.1
Instructions for use
Instructions – fi lling
• Check that all ball valves are closed.
• Ultrasound and heating must be turned off.
• Do not
fi
ll ultrasonic tank with hot water. Maximum
fi
lling temperature: 50 °C.
• At least drinking-quality water must be used to
fi
ll the oscillating tank.
• Water without additives is not suited for sonication. BANDELIN recommends the
TICKOPUR or STAMMOPUR preparations.
• The
fi
ll level must always be at or slightly above the
fi
lling level mark.
A low
fi
ll level will damage the ultrasonic bath!
This may happen when used for extended periods, for example as a result of
evaporation. In such cases, the ultrasound and possibly the heating must be
switched off (controller on 0). Once the tank is
fi
lled up, the ultrasound and the
heating, if applicable, can be switched back on.
• When using with a liquid circuit (with FA, OX, WA or cascade pipes) the additional
fi
ll
volume of the peripheral devices must be taken into account:
Fill the ultrasonic bath with water and cleaning concentrate (in the appropriate dose!)
up to the weir's toothed edge
Follow the dosing instructions for the concentrate
used. Also
fi
ll all additional tanks up to the weir with municipal or DI water.
• Do not use any combustible
fl
uids (e.g. benzine, solvents) or chemicals that
contain or separate out chloride ions (some disinfectants, household cleaners and
dishwashing detergents) for sonication in the stainless steel tank.
• When using preparations, the safety instructions included in the product lea
fl
ets must
strictly be adhered to.
• Replace used sonication
fl
uids, do not refresh by adding
fl
uids.
Notes - Inserting objects
• Fully remove air bubbles from cavities (e.g. blind holes).
Sonication
fl
uid
Insert basket