Controll-A-Door
®
Diamond PD & Roll-A-Pro
TM
Home Owner’s Manual
10
8. Coding Transmitters
Press
CODE SET
button once
Select one of the
four buttons you
wish to use to
control the door
Fig. 8.1
ELECTROCUTION!
The button
cover is the only cover that should
be removed. All other covers must
remain in place.
CAUTION:
Be careful not to press
the operate button while removing
the button cover as the door will
start to move.
8.1 Storing the Transmitter Code
The opener can only operate from transmitters that
have been programmed into its receiver. The receiver
needs to learn the codes of any transmitter that will
be used with the operator. Up to sixty four (64) codes
(Diamond PD) or eight (8) codes (Roll-A-Pro
TM
) can be
stored in the receiver’s memory.
a. Ensure that the battery is inserted in the
transmitter.
b. Press the CODE SET button and release. The
CODE SET LED will illuminate to indicate the
opener is in Code Learn mode. If a valid code is
not stored within 15 seconds the opener will exit
Code Learn.
(Fig 8.1)
c. Press one of the four (4) buttons on the transmitter
for two (2) seconds, the CODE SET LED will
begin to flash, pause for two (2) seconds, then
press the same button again for two (2) seconds.
d. The transmitter button is now coded - press to
test.
8.2 Setting the Courtesy Light
Although the courtesy light comes on with each
operation of the opener, it may also be controlled by a
transmitter without operating the door.
a. Press the CODE SET button twice - the CODE
SET LED and courtesy light will both illuminate.
b. Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds.
The CODE SET LED will illuminate for one second
then go out.
c. Press the transmitter button to test.
8.3 Setting the Vacation Mode
The opener can be programmed into a “Vacation
Mode” where the opener will not respond to any
transmitter except one preprogrammed unit.
a. Press the CODE SET button three (3) times - the
CODE SET LED will illuminate and the courtesy
light will flash slowly.
b. Press one of the four (4) buttons on the transmitter
for two (2) seconds, the CODE SET LED will
begin to flash, pause for two (2) seconds, then
press the same button again for two (2) seconds.
c. The CODE SET LED will illuminate for one second
and then go out, and the courtesy light
will also switch off. This indicates the
code has been stored.
d. Press and hold the transmitter button for
five (5) seconds to set Vacation Mode.
The CODE SET LED will stay lit while
Vacation Mode is active.
e. To reset Vacation Mode, press the same
button for two seconds, until the CODE
SET LED turns off.
IMPORTANT NOTE:
Only Tri-Tran+
TM
Technology Transmitters are compatible
with these RDO-1 products.
TB-6 Shown
