13
Controll-A-Door
®
S & PanelPro
Instruction Manual
Setting the Transmitter to Operate PET (Pedestrian) Mode
The PET mode position (see Programming the Opener) must set prior to
coding a transmitter.
a. Press the DOOR CODE button five (5) times - the DOOR CODE LED will
illuminate and the courtesy light will flash quicky (twice per second).
b. Press one of the four (4) buttons on the transmitter for two (2) seconds,
the DOOR CODE LED will begin to flash, pause for two (2) seconds, then
press the same button again for two (2) seconds.
c. The DOOR CODE LED will illuminate for one second and then go out,
and the courtesy light will also switch off. This indicates the code has
been stored.
d. Press the transmitter button to test.
Installation of the Wall Mounted Transmitter
a. Mount the transmitter in a convenient location, yet out of reach of
children and at least 1.5m off the ground.
b. Make sure the door is visible from this location.
c. To set the transmitter press the DOOR CODE button and release. The
DOOR CODE LED will illuminate to indicate the opener is in Code Learn
mode. If a valid code is not stored within 15 seconds the opener will exit
Code Learn.
d. Press the transmitter button (one of four) that you want to control the
door. The DOOR CODE LED will flash.
e. Press the same transmitter button again. The DOOR CODE LED will
illuminate for one second then go out.
f. The transmitter button is now coded - press to test
Remotely Coding Transmitters
Using this method transmitters can be coded without access to the
opener’s control panel as long as a pre-coded transmitter is available.
a. Take any pre-coded transmitter. Press the button for the function to be
duplicated and release.
b. Using a small needle / pen, press and hold firmly for two seconds the
middle button, through the Coding Hole.
c. Within ten (10) seconds take the additional transmitter you wish to
code. Hold the new transmitter’s button for two seconds, pause for two
seconds, hold again for two seconds and then release.
d. Wait for ten (10) seconds and then press the new transmitter’s button
to test.
Erasing Programmed Codes
If the DOOR CODE button is pressed and held for six (6) seconds the DOOR
CODE LED will blink rapidly for one second to indicate that all programmed
codes have been erased.
14. Coding a Transmitter
