TERMS OF LIMITED WARRANTY
Limited Warranty is only applicable to products installed for use in HVAC systems using clean potable water. Complete
unit replacements are not covered, defective parts will be repaired and/or replaced at the Manufacturer
’
s discretion.
Limited Warranty shall not apply if serial number or data plates have been removed or altered. Warranty will be null and
void. Limited Warranty shall not apply if products are not installed and maintained according to instructions in the
product installation manual. Replacement and/or factory repaired parts are warranted only for the remainder of the
original warranty period.
B&D Mfg., Inc. does not warrant products that have been modified from original design. Any product returned with
design deviations will null and void any and all warranties. B&D Mfg., Inc. is not responsible for any labor, shipping and
transportation costs. In no event will liability exceed the purchase price of the product.
SAFETY CONSIDERATIONS
Installing and servicing of the Rotational Control (BDCB
-
RC4HP) can be hazardous due to electrical components. Only
trained, qualified personnel should install, start
-
up and service this equipment.
When working on the equipment, observe precautions in the literature, tags, stickers and labels attached to the
equipment and to any other safety precautions that apply.
When the Rotational Control (BDCB
-
RC4HP) is operating, some components you should not touch. Personal injury can
result from touching these items with any object.
All electrical and service access panels must be returned and secured in their proper place. Clear surrounding area of all
tools, equipment and debris. Check the entire unit to ensure its cleanliness.
Follow all safety codes. Wear safety glasses and work gloves.
Scranton, IA 51462
Phone (712) 652
-
3424
www.bdmfginc.com
2
INSTALLATION PRECAUTIONS
Installation of the Rotational Control (BDCB
-
RC4HP) should only be performed by a licensed contractor to ensure
proper installation and the safety of the installer. The following are some precautions to be followed for typical
installations.
•
Always use proper tools and equipment
•
No wiring or other work should be attempted without first ensuring that the Rotational Controls Package
(BDCB
-
RC4HP) is completely disconnected from the power source and locked out. Always verify that a good
ground connection exists prior to energizing any power sources.
•
Always review the nameplate on each unit for proper voltage and control configurations. This information is
determined from the components and wiring of the unit.