Chapter 8
Maintenance Instructions
Before any maintenance is performed, the machine must be stopped, the ironing cylinder cold,
and power removed from the machine. Follow all lock-out/tag-out procedures.
8.1
Replacing Infeed Belts
•
Remove the 2 screws holding the introduction tray.
•
Unlock the axis of the driving roller on the side of the left block (2 pointed screws).
•
Unwind approximately half a turn of adhesive strip.
•
Push away the pin while maintaining the axis in place (identify the direction in which the
axis is mounted).
•
Remove the axis by pushing on the left.
•
Withdraw the introduction tray.
•
Remove the used infeed belts and replace with new belts.
•
To reassemble, reverse the instructions above.
•
Glue the adhesive strip back on using neoprene glue.
•
Check the distance between the end of the introduction tray and the roller. The distance must
be a minimum of 5 to 6mm.
Note: always change the full set of belts.
37
