B&B Electronics, Inc.
SPECTRE Configuration Manual
61
710-10001-02 Rev. 3.0
www.bb-elec.com
www.bb-europe.com
Note:
If no phone number is filled in, the router will accept incoming messages from all phone
numbers. If any phone numbers are entered into the list, the router will only accept SMS
messages which originate from those numbers.
Control SMS messages cannot change the router configuration. Any changes made to
the router by an SMS message will only remain in effect until the router is restarted. After a
reboot, the router configuration will return to the settings in non-volatile memory. For example, if
the router is switched offline by an SMS message, the router will remain offline until the next
time it is power cycled or re-booted.
To control the router using SMS, the message text must contain the control command.
Table 48 lists the SMS control messages that are supported.
SMS Control Message
Description
go online sim 1
Switch to SIM1 card
go online sim 2
Switch to SIM2 card
go online
Switch router in online mode
go offline
PPP connection termination
set out0=0
Set binary I/O output to 0
set out0=1
Set binary I/O output to 1
set out1=0
Set binary output on port 1 to a 0
set out1=1
Set binary output on port 1 to a 1
set profile std
Set standard profile
set profile alt1
Set alternative profile 1
set profile alt2
Set alternative profile 2
set profile alt3
Set alternative profile 3
reboot
Router reboot
get ip
Router will send an SMS message back with the IP address from
the SIM card.
Table 47: SMS Control Commands
You may send and receive SMS messages using either the serial expansion ports or a
TCP connection over the Ethernet network. For serial communication, the baud rate must be set
to match the attached host. Select option
Enable AT-SMS protocol on expansion port 1
to
allow messages to be sent and received using serial port 1.
Item
Description
Baud rate
Communication speed expansion port 1
Table 48: Send SMS on serial PORT1 configuration
Select option
Enable AT-SMS protocol on expansion port 2
to allow messages to be
sent and received using serial port 2.
Item
Description
Baud rate
Communication speed expansion port 2
Table 49: Send SMS on serial PORT2 configuration
It is also possible to send and receive SMS messages over a TCP/IP connection by
choosing
Enable AT-SMS protocol on TCP port.
The TCP port used for sending and receiving
SMS messages must be entered into the configuration field.
