36
8. Technician's Manual
– Must be performed by a technician –
8A. Installation and Assembly
8A-1 Assembly Preparation
8A-1-1 Number of Workers and Work Time
The following numbers of workers and work times are required for assembly work.
Number of workers
Delivery work: See "6-2 Transportation".)
Assembly work: Two or more technicians
Work time
Assembly work: Approximately one hour
8A-1-2 Workflow
Carry out the assembly work in the following order.
[1] Assemble the seat assembly.
[2] Insert the USB dongle.
[3] Adjust the level adjuster.
[4] Connect the power cord, ground wire, and LAN cable.
[5] Turn the power switch on.
[6] Disassemble the machine (when transporting the machine manually).
8A-1-3 Space Required during Installation
An open space of 3 m x 3 m or larger with a ceiling height of 2.5 m or higher is required for
assembly and installation.
8A-1-4 Required Tools and Parts
The following tools are required for assembly and installation.
• Phillips-head screw driver (No. 2)
• Torx wrench (for M5, T25) * supplied
• Allen key (width across flats: 6 mm)
• Wrench (width across flats: 24 mm)
• A stepladder or a footstool
• Light (when needed)
U.S. and European models are not equipped with coin selectors when they are shipped. See "(1)
Replacing the Coin Selector (U.S. Model)" or "(4) Replacing the CASHFLOW (European Model)" to
install a coin selector.
If connection to the NBLINE is necessary, refer to "8A-5-2 Connecting the LAN Cable to the
Machine" and connect the LAN cable.
