Bambi VT75, Руководство оператора

Страница: 4 / 32

2
3) Unpacking Instructions for:
VTS75 / VTS150 / VTS200/ VTS250
3.1) Fitting Mounting Castors
Before using the compressor you must remove the external packaging and fit the
castors supplied as they also provide essential clearance for the lower cooling fan
exhaust.
Note !
Failure to do so will cause damage and invalidate your warranty
Remove the four bolts securing the compressor to its wooden packing, carefully lift
the compressor to enable you to screw in the four castors using the same mounting
holes.
Take care lifting the compressor, some models are heavy.
3.2) Removing Internal Transit Packing
Before using the compressor you must remove the internal packing, failure to do so
will cause damage to the compressor. The procedure is as follows -
3.3) Fitting Condensate Bottle – VTS Dryer models only
Compressors fitted with an air dryer are supplied with a
condensate bottle which you will need to fit before use.
Attach the condensate bottle mounting bracket to the front panel
of the compressor using the 2 plastic clips provided. These are
a simple push fit.
Slide the condensate bottle into the mounting bracket.
Fig.2 - VTS Condensate bottle position
Push the black plastic condensate tube which emerges from the front panel into the
hole in the lid of the bottle. As on Fig. 2
Fit the exhaust silencer to the condensate tube by pushing firmly on to the end of the tube.
Fit the bottle lid ensuring that it “clicks” home.
Using the hex key provided,
remove the 3 bolts fixing the
left hand end cover in place
(when viewed from the front)
– see fig 1.
There are three packing
pieces, two either side of the
pump unit, one on top of the
cooling fan assembly.
Ensure that these are
removed.
Reassembly is a reverse of the above but do not over-tighten the cover fixing bolts.
Using the hex key
provided, remove the 4
bolts fixing the top cover
in place and remove the
top cover
- see fig 1a.
There is one packing
piece on the top of the
pump unit.
Ensure that this is
removed.
VTS75/150/200 VTS250D
Fig 1.
Fig 1a.