baltur TBML 2000 ME, Инструкция по установке, использованию и обслуживанию

Страница: 56 / 88

HEAD UNIT ASSEMBLY
For burner handling, use certified chains or ropes suitable for the bur -
ner weight using the anchoring points (21).
CAUTION / WARNINGS
Make sure that the combustion head is long enough to enter the
furnace to the extent specified by the boiler manufacturer.
Anchor the burner to the boiler as follows:
• Position the insulating seal on the sleeve (13).
•
Anchor the flange of the head unit (15) to the boiler (1) with the
stud bolts, washers and nuts provided (7).
DANGER / ATTENTION
Seal the space between the burner sleeve and the hold on the
refractory material inside the boiler door completely with suitable
material.
ASSEMBLING THE GAS TRAIN
The EN 676 approved gas train is sold separately from the burner.
The gas train can be assembled in different ways.
The gas train connection must face downwards.
In order to have the maximum opening, hinge pin (4) must be in the
position opposite the gas train.
If the gas train must be installed on the same side as the hinge pin, fit a
stub pipe connector - big enough to allow the burner to open - between
the expansion tank and the gas train fitting.
Place a gasket like the one supplied with the gas train between the
stub pipe connector and the expansion tank.
ACOUSTIC SHROUD
If it is necessary to reduce the sound pressure level, install a suitable
acoustic shroud. (see technical price list and contact the dealer) ).
1
7
7
15
13
0002951230N3
21
21
0002951230N4
4
4
0002951230N5
0002570290N5
12 / 42
0006160409_202305
ENGLISH