baltur TBML 1600 ME, Инструкция по установке, использованию и обслуживанию

Страница: 71 / 84

MAINTENANCE
Analyse combustion gases and check that the emission values are
correct at least once a year, in compliance with current law.
• Clean air dampers, the air pressure switch with pressure port and
the relevant pipe, if any.
• Check the electrode condition. Replace them, if necessary.
• Clean the flame sensor, replace it if necessary.
• Have the burner and the chimney cleaned by specialised person -
nel (stove repairer); a clean burner is more efficient, lasts longer
and is quieter.
• Check that the fuel filter is clean. Replace it, if necessary.
• Check that all components of the combustion head are in good
condition, have not been deformed and are free from deposits
deriving from the installation environment and/or from poor
combustion.
• Analyse combustion gases and check emissions values.
If the combustion head needs to be cleaned, remove the components
following the procedure indicated below:
• remove the flame sensor;
• Disconnect the connectors of gas solenoid valves, diesel and gas
servomotor.
• unscrew the anchoring screws (12), and open the ventilating
body;
• pull out the ignition cables (14) from their electrode terminals (13);
• unscrew the screw (8) from the buffer (17)
• Pull out the entire mixer unit in the direction shown by the arrow.
When you have finished maintenance work, proceed to reassem -
ble the combustion head, following the same procedure in rever -
se, after checking the correct position of the ignition electrodes.
12
8
12
14 13
0002950790
00061
10799
8
17
29 / 40
0006160375_202305
ENGLISH