baltur TBG 900 ME, Инструкция по установке, использованию и обслуживанию

Страница: 50 / 60

MAINTENANCE
Analyse combustion gases and check that the emission values are
correct at least once a year, in compliance with current law.
Carry out the following operations at the end of the heating season:
• Clean air dampers, the air pressure switch with pressure port and
the relevant pipe, if any.
• Check the electrode condition. Replace them, if necessary.
• Have the burner and the chimney cleaned by specialised personnel
(stove repairer); a clean burner is more efficient, lasts longer and is
quieter.
• In order to clean the combustion head, its outlet components must
be disassembled. Be careful during the reassembly operations to
exactly centre the gas diffuser with respect to the electrodes, making
sure that they are not earthed, which would result in the locking of
the burner. Verify also that the ignition electrode spark takes place
exclusively between itself and the drilled disk (see combustion head
and electrode disk distance regulation diagram) for the version wi-
thout pilot.
• Analyse combustion gases and check emissions values.
• Check that all components of the combustion head are in good con -
dition, have not been deformed and are free from deposits deriving
from the installation environment and/or from poor combustion.
If the combustion head needs to be cleaned, remove the components
following the procedure indicated below:
• unscrew the anchoring screws (12) and open the ventilating body;
• pull out the ignition and ionisation cables (14) from their electrode
terminals (13);
• unscrew the screw (16) from the buffer (17).
• pull out the entire mixer unit in the direction shown by the arrow.
• When you have finished maintenance work, proceed to reassemble
the combustion head, following the same procedure in reverse, after
checking the correct position of the ignition electrodes.
20 / 28
0006160267_202106
ENGLISH