baltur TBG 600 ME, Инструкция по эксплуатации

Страница: 29 / 84

11 / 16
0006081514_201 204
00
15
00
14
ENGLISH
USING THE BURNER
The burner operates fully automatically: it is activated by closing
the main switch and the control board switch. Burner operations are
controlled by command and control devices, as described in chapter
“Operation description”. The “block” position is a safety position
automatically taken up by the burner when a particular part of the
burner or of the system is inefficient. Therefore, it is good practice,
before unblocking the burner and starting it up again, to check that
there are no defects in the heating plant. The length of time that
the burner rests in the “block” position is without limit. To unblock
the control box, press the appropriate pushbutton (unblock).
Blocks can be caused by transitory flows (a little water in the fuel,
air in the pipes, etc.); in these cases, if unblocked, the burner will
start up normally. When, however, blocks occur repeatedly (3 or
4 times), do not persist in trying to unblock the burner, first check
that there is fuel in the tank and then call the Technical Assistance
Service to repair the defect.
AIR REGULATION SERVOMOTOR
AIR SHUTTER POSITION INDEX
GAS VALVE POSITION INDEX