The River, User Manual
PAGE
34
PAGE
34
*
S RATE DELAY (0 ... 127)
fall time when the waveform is of type AR envelope.
S RATE DELAY (0 ... 127)
fall time when the waveform is of type AR envelope.
The following four settings allow precise measurement of the influence on the modulation controller. When a parameter is a
maximum, the amplitude / DLFO speed will be dependent on 100% of this parameter. Example: If Wheel = 127, you can observe
a DLFO activity if the wheel leaves its position of "rest." Only in this case as you can also see a possible influence of the velocity
or aftertouch.
If all four parameters are 64 (the middle), it means that the output of DLFO will always be active with an average amplitude even if
these four parameters are inactive. Also, each of them may affect with the same weight on the amplitude / speed DLFO.
WHEEL (0 ... 127)
modulation of the speed and / or amount of DLFO by the modulation wheel.
WHEEL (0 ... 127)
modulation of the speed and / or amount of DLFO by the modulation wheel.
VELOCITY (0 ... 127)
the modulation speed and / or amount of DLFO by typing speed.
VELOCITY (0 ... 127)
the modulation speed and / or amount of DLFO by typing speed.
AFTERTOUCH (0 ... 127)
modulation of the speed and / or amount of DLFO by key pressure.
AFTERTOUCH (0 ... 127)
modulation of the speed and / or amount of DLFO by key pressure.
*
S PEDAL IN (0 ... 127)
modulation of the speed and / or amount of DLFO by the pedal.
S PEDAL IN (0 ... 127)
modulation of the speed and / or amount of DLFO by the pedal.
7. SEQ MOTION
7. SEQ MOTION
This is a sequencer for modulating movements of some synthesis parameters in real time, on a maximum of 16 not,
cyclically. These parameters are indicated by a blue dot:
-
Octave (32-16-8-4) of each VCO
-
INTERVAL of VCO2
-
LEVEL source of each mixer (VCO1, VCO2, NOISE)
-
CUTOFF filter
-
EMPHASIS VCF.
at. Record a sequence
at. Record a sequence
Push the button
*
S RECORD (
SYNC) button.
Push the button
*
S RECORD (
SYNC) button.
Push the button
*
S RECORD (
SYNC) button.
Push the button
*
S RECORD (
SYNC) button.
Adjust the position of the desired parameters and then play a note: the position is recorded and the next step is selected.
Adjust the new position of the parameters for this step, etc.
b. End recording
b. End recording
Push the button
*
S PLAY
or press again
*
S RECORD.
Push the button
*
S PLAY
or press again
*
S RECORD.
Push the button
*
S PLAY
or press again
*
S RECORD.
Push the button
*
S PLAY
or press again
*
S RECORD.
Push the button
*
S PLAY
or press again
*
S RECORD.
Push the button
*
S PLAY
or press again
*
S RECORD.
Содержание The River
Страница 1: ...user s Guide Version 2 0 November 2018 ...