Bally Revenge from mars Pinbal 2000, Руководство по эксплуатации

Страница: 18 / 132

1-6
10. Slide the three cables back inside the backbox and connect them. Do not force cables onto
connectors, they should plug in easily . See Figure 8, on page 1-4 to identify the cables. Route each
cable through the unused plastic clamps attached to the inside of the cabinet.
Plug the 9-pin serial cable into the bracket near the coin door and screw it securely in place (see
Figure 11 below). Plug the 25-pin parallel cable into the Power Driver board at J100 and screw it
securely in place. The power/speaker cable has two connectors, a 2-pin connector for the speakers
and a 3-pin connector for power. Plug the speaker cable connector into the 2-pin connector near the
speakers, and plug the power cable connector into the 3-pin isolation tap from the transformer, which
is also located near the speakers. Be sure to match the wire colors on the speaker and power
cables.
Coin Door Interlock
Switch Assembly
A-23024
FIGURE 11
The last cable to attach is the ground strap. The ground strap is located in the rear of the cabinet
(see Figure 8 on page 1-4 for ground strap location). Reach through the rectangular hole and pull the
ground strap up. Remove the wing nut from the ring lug located to the left of the rectangle hole. Slip
the ground strap loop over the ring lug and secure it in place with the wing nut. Replace and lock the
backbox rear door. Replacing the screws is optional.
11. Lean the playfield against the cabinet front and plug the cables back into the rear bracket.
12. Carefully, lift the playfield from the front and tip the back of it onto the slides. Slide it back into the
cabinet. Be sure that the cables at the back of the playfield are not kinked.
13. Rest the front of the playfield on the top of the cabinet as you did in Step 2. Open the coin door.
Lower the playfield all the way into the cabinet. Close and lock the coin door.
14. Be sure the
required number of balls is installed.
15. Replace the playfield glass. Be sure that the PINBALL 2000 logo is in the lower left corner. See
Figure 12 below. Snap the front molding securely into place. Close and lock the coin door.
FIGURE 12