II. INSTALLATION
A. Assembly (See Figure
1)
1.
Using flat washers under bolt heads, bolt legs to cabinet.
2.
Unlock and remove back glass from back box, loosen screws on light panel retaining brack
3.
Position back box on cabinet, lift and tilt light panel forward to rest on cabinet for acceSl
main cable and printed circuit board.
4. Bolt back box to cabinet.
5.
Gently feed cable connectors and ground braids from cabinet through port in back box.
6.
Bolt ground braids to stud on power supply chassis.
7.
Carefully and fully insert (4) back box cable connectors into cabinet connectors.
8.
I nsert power supply cable connector completely into receptacl e on chassis.
B. Inspection
After assembl y, a visual inspection of the game must be made to correct loose connections or
proper switch adjustments that may occur due to rough handling during shipment.
Caution: Do not plug in line cord before completing the following steps:
1.
Check that all cable connectors are completely seated on printed circuit assemblies.
2.
Check that all cables are clear of moving parts.
3.
Check for any wires that may have become disconnected.
4. Check switches for loose solder or other foreign material that may be shorting contacts.
5.
Check that fuses are firml y seated and making good contact.
6.
Check that integrated circuits mounted on P.C. sockets are firmly seated.
(Continued)
