Balluff BVS HS-Q Series, Руководство по эксплуатации

Страница: 146 / 296

146
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Codabar Set Length 1
This feature specifies one of the barcode lengths for Codabar Length Control on page 145Cod-
abar Length Control on page 145 . Length 1 is the minimum label length if in Variable Length: For
variable length decoding, a minimum and maximum length may be set. on page 231 Mode, or the
first fixed length if in Fixed Length: For fixed length decoding, two different lengths may be set. on
page 231 Mode. Length includes the barcode’s start, stop, check and data characters. The
length must include at least one data character. The length can be set from 3 to 50 characters.
Table Codabar Length 1 Setting Examples provides some examples for setting Length 1. See
page 232 for detailed instructions on setting this feature.
Codabar Length
1 Setting
Examples
STEP ACTION EXAMPLES
1
Desired Setting
(and pad with
leading zeroes)
03 Characters 09 Characters 15 Characters 50 Characters
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT CODABAR LENGTH 1 SETTING
4
Scan Two
Characters
From
Appendix
18, Use the
barcodes in this
appendix to
enter numbers
as you would
select digits/
characters from
a keypad.
‘0’ and ‘3’ ‘0’ and ‘9’ ‘1’ and ‘5’ ‘5’ AND ‘0’
5 Scan ENTER/EXIT PROGRAMMING MODE
Select Codabar Length 1 Setting
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You can
then start again at the beginning.
CANCEL
$CCBL1
~
DEFAULT
03 = Length 1 is 3 Characters