www.balluff.com
9
3
Setting Up the Reader
BVS HS-PC
Industrial Corded Handheld Barcode Reader
3
Setting Up the Reader
Follow the steps below to connect and get your reader up and commu-
nicating with its host.
1
Connect the Cable to the reader and the Host, shown
on page 9
.
2
Configure the Interface (
see page 11
).
3
Configure the Reader starting
on page 19
(optional, depends on
settings needed)
Connect the BVS HS-PC readers hand held by plugging directly into the
host device as shown. The power can also be supplied through an exter-
nal power supply via the Interface Cable supplied with a power jack.
3.1
Connecting the Cable
A. Rubber gasket
B. Cable Holder
C. Cover
D. Connector Holder
1
Slip the cable through the
Cover.
2
Push the Rubber Gasket
onto the Cable Holder.
3
Push the Cable Holder and
gasket into the handle.
Ensure that the “Front”
marking on the Cable Holder
is facing out, with the arrow
pointing towards the front of
the scanner.
4
Insert the end of the cable
into the socket of the Cable
Holder.
5
Push the Cover along the
cable towards the reader,
and hook it over the yellow
“tooth” on the back of the
handle.
6
Insert the cable through the
Connector Holder, and push
it up into the Cover.
7
Insert and tighten the screw
to affix the cable assembly
to the reader handle.
A
B
C
D
FRONT>>
1
2
3
6
4
5
7
