Balluff BTL7-A50 Series, Руководство пользователя

Страница: 33 / 115

10 english
4.3 Installing the transducer
NOTICE!
Interference in function
Improper installation can compromise the function of the
transducer and result in increased wear.
►
The mounting surface of the transducer must make
full contact with the supporting surface.
►
The bore must be perfectly sealed (O-ring/flat seal).
►
Make a mounting hole with thread (possibly with
countersink for the O-ring) acc. to Fig. 4-3, Fig. 4-4 or
Fig. 4-5.
►
Screw the transducer thread into the mounting hole
(max. torque 100 Nm for M18x1.5 and 3/4"-16UNF;
max. 150 Nm for M30x1.5).
►
Install the magnet (accessories).
►
For nominal lengths > 500 mm: Tighten the outer rod
at the end or support it.
Suitable nuts for the mounting thread (for the
BTL7...-TZ/TB...) are available as accessories
(see page 18).
4.3.1 Installation recommendation for hydraulic
cylinders
If you seal the bore with a flat seal, the max. operating
pressure will be reduced in accordance with the larger
pressurized surface.
If installing horizontally in a hydraulic cylinder (nominal
lengths > 500 mm), we recommend affixing a slide element
to protect the rod end from wear.
Dimensioning of the detailed solutions is the
responsibility of the cylinder manufacturer.
The slide element material must be suitable for the
appropriate load case, medium used, and application
temperatures. E.g. Torlon, Teflon or bronze are all possible
materials.
Fig. 4-6:
Slide element
Magnet
Example 1, transducer installed with slide element
The slide element can be screwed on or bonded.
►
Secure the screws so they cannot be loosened or lost.
►
Select a suitable adhesive.
Slide element
BTL rod
Piston rod
Slide surface
Flow gap
Fig. 4-7: Detailed view and top view of slide element
There must be a gap between the slide element and piston
bore that is sufficiently large for the hydraulic oil to flow
through.
Options for fixing the magnet:
– Screws
– Threaded ring
– Press fitting
– Notches (center punching)
If installed in a hydraulic cylinder, the magnet
should not make contact with the rod.
The hole in the spacer ring must ensure optimum guidance
of the outer rod by the slide element.
Fig. 4-8:
Spacer ring
Magnet
Fixing of magnet
Fixing of magnet
An example of how to install the transducer with a
supporting rod is shown in Fig. 4-9 on page 11.
4
Installation and connection (continued)
BTL7-A/C/E/G50_-M_ _ _ _ -T_2/3-S32/S135/KA_ _/FA_ _
Micropulse Transducer - Rod Style