Balluff BNI EIP-104-105-Z015, Руководство пользователя

Страница: 10 / 20

www.balluff.com
9
4 Technical data
4.5. Ethernet
Ethernet IP port 1 x 10Base-/100Base-Tx
Connection for Ethernet IP port M12, D-coded
Cable types per IEEE 802.3 Shielded twisted pair min. STP CAT 5/ STP CAT 5e
Data transmission rate 10/100 Mbit/s
Max. cable length 100 m
Flow control Half Duplex/Full Duplex (IEEE 802.33x-Pause)
4.6. Function
indicators
Module status
LED Status Function
UA
green Output power OK
red Low Output power (< 18V)
US
green Input power OK
red Low Input power (<18V)
Mod
green flashing Wrong or no configuration on module
green Modul operating
red flashing Fixed busclock is not possible
red-green flashing Initial sequence
Net
off Module got no IP address
green flashing Module got IP, but no connection could be established
green Connection established
red flashing Connection timeout
red-green flashing Initial sequence
100
off Bus clock: 10 Mbit/s
yellow Bus clock: 100 Mbit/s
LNK green Data transfer
Port
Each Port has two two-colour LEDs to indidcate the I/O-States.
Status Function Description
I/
O
Po
rt
off I/O-State State of the Input or Output Pin is 0
yellow I/O-State State of the Input or Output Pin is 1
red Short-circuit single LED: Short-circuit on dedicated Pin (only if
this pin is used as an output)
both LEDs:
Short-circuit between Pin 1 and 3 or
Short-circuit on both output pins
Status-LEDs
Port LEDs
Port-Leds