Balluff BIP LD2-T017-04-BP S4 Series, Руководство пользователя

Страница: 29 / 142

4.1 Electrical connection
Fig. 4-1:
1
2
4
Pin assignment of S4 connector
(view from above on connector of BIP)
Connector/
pin
Wire
color
Signal
1 Brown L+ (18
…
30 V)
2 – Not used
1)
3 Blue L– (GND)
4 Black C/Q (communication line)
1)
Unassigned leads can be connected to the GND on the controller side
but not to the shield.
Tab. 4-1: Connection assignments
4.2 Cable routing
Defined ground!
The BIP and the control cabinet must be at the
same ground potential.
Magnetic fields
The BIP operates according to the eddy current principle.
It is important to maintain adequate distance between the
BIP and strong, external magnetic fields.
Cable routing
Do not route the cable between the BIP, controller, and
power supply near high voltage cables (inductive stray noise
is possible).
Inductive stray noise from AC harmonics (e.g. from phase
angle controls) are especially critical and the cable shield
offers very little protection against this.
Cable length
Max. cable length 20 m. Longer cables may be used
if their construction, shielding and routing prevent noise
interference.
Bending radius for fixed cable
The bending radius for a fixed cable must be at least three
times the cable diameter.
4
Connection
www.balluff.com 7 english
BIP LD2-T017-04-BP _ _ / BP _ _ -S4
Inductive Positioning System