Page 4 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(A)
(D)
(B)
(C)
WALL S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
WALL ANCHORING HARDWARE (ANTI-TIP) INCLUDED WITH CABINET/CONSOLE BASE
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
Ltr.
A
4
Small Screw
Retention Belt
Qty.
Hardware Included
B
4
Large Screw
C
4
Bracket
D
2
1. Place Hutch against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) into WOOD BANDING on back of Hutch
using Small Screws (A). If Screw is not driven into wood it may pull out during a tip-over.
*NOTE: HUTCH MUST BE ATTACHED WITH BRACKETS TO BASE CONSOLE!
3. To keep hardware out of view after installation, attach remaining Bracket (C)
INTO WALL STUD
with Large Screws (B) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
ATTENTION:
Do not anchor Consoles to wall onto which a Hutch is to be installed.
Hutches are anchored to wall after attachment to Console Bases.
IMPORTANT
*Hutch MUST be bracketed to
Console Base.
Anchor HUTCH to Wall Stud.
Do not anchor Console Bases
when topping with a HUTCH.
Anchor Hutch ONLY
