Fig. 1
Fig. 2
SHELVES:
Use a Phillips Screwdriver to
remove Set Screws. Lift Shelf (G) out.
Remove and reposition Shelf Supports (E).
Replace Shelf then reinsert and tighten Screws.
LEVELERS:
Console (SOLD SEPARATELY) is
equipped with Rotary Levelers. If necessary, adjust-
ments may be made by carefully lifting applicable
corner and turning Leveler clockwise/counterclockwise.
Cabinet/Console base
SOLD SEPARATELY
Adjust Levelers BEFORE anchoring
unit to wall.
Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
WARNING: To prevent a dangerous tip-over accident, Hutch must be secured to
base using Brackets as illustrated in this step.
SETUP:
SINGLE:
Place Trieste Console (sold separately) in location for installation then carefully lift
and place Hutch (F) onto Console top. Align side and back edges then position two Connector Plates (D)
as illustrated (Fig. 1). Secure using Allen Bolt (A) with Flat Washer (B). Snap on Moulding (H)
MULTIPLE:
Complete steps above then use Connector Plates (D) to join and secure all units (Fig. 2).
NOTE: Console and Hutch units all sold separately.
(D)
(A)
(A)
(B)
(B)
(C)
(C)
(H)
Use Moulding on open ends.
Omit when joining multiple units.
NOTE
(D)
(G)
(E)
