Lamp is provided optimal support when
attached directly to a WALL STUD.
*NOTICE
Unplug lamp prior to installation or removal. Turning off switch is not sufficient.
STEP 1: PREPARE FIXTURE
Carefully align Cord Covers then thread and
tighten together. Gently pull excess cord
through bottom Cover.
STEP 2: PREPARE MOUNTING HARDWARE
Carefully Remove Backplate Side Screws (C)
from sides of Fixture Body (A) and set aside.
Separate Mounting Bracket (D) inside Fixture
Backplate.
STEP 3: INSTALL MOUNTING BRACKET
Determine installation location then use Mounting
Bracket (D) and pencil to mark for both Key Holes
in Bracket.
If holes are located over a *Wall Stud, drive
Mounting Screws (B) directly into Stud.
If holes are in open drywall, use Wall Anchors (E)
with Mounting Screws.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Page 3 of 4
(C)
(A)
(D)
1
Mark location.Drill small pilot hole with 3/8” bit.
2
Gently tap Anchor into pilot hole.
3
Add item/Align holes. Add/tighten screw.
INSTALLING WALL ANCHORS
Cord Covers
