Page 3 of 4
STEP 1:
NOTE: Before starting assembly of this Lamp, be sure it has been unplugged.
Turning the switch off is not sufficient enough.
Screw the Pole (A) into the Stem (B) until tight.
Then screw the Stem into the Base (D). Slowly
pull the wire out of the bottom of the base.
STEP 2:
Screw the Rod (C) into the Pole (A) until tight.
Adjust the Pole to your desired height. Attach
the end of the Chain to the Stem (B) as shown.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(B)
(A)
(D)
(C)
(A)
(B)
