Á>UÁ¿É¸¿tµ¿>¸¸¸Á>Ug[¿¿£l½½¤¿lu¼l¼¼¿¿N¿¿ÑÑѦ
L>ggg¦U
¿
¿¿¿¿¿¿
6
ASSEMBLY
3
Hardware Required:
1
Cam Bolt x7
7
Runner x4
8
Screw (3x12mm) x12
?
Foot Pad x2
8
7
B
7
8
1
1
1
1
1
FRONT
BACK
FRONT
BACK
FRONT
BACK
FRONT
8
7
FRONT
BACK
7
8
FRONT
BACK
D
1
1
FRONT
BACK
FRONT
Install the Drawer Runners
7
on the Left Side
B
and Middle Panel
D
.
Fully extend one Runner and align the inner section along one set of 3 small holes on the Left Side as shown.
Verify
that the orientation of the Runner matches the diagram, then fasten the Runner to the Divider using 3 Screws
8
positioned as shown. Once the Runner is attached, slide it back to the closed position. Attach the second Runner to
the Left Side following the same method, checking orientation before inserting Screws. Install the Runners on the
Middle Panel in the same way.
Insert a total of 5 Cam Bolts
1
into the indicated holes above and below the Runners on the Left Side and 2 Cam
Bolts on the Middle Panel.
Apply Foot Pads
?
to the bottom of the Left Side legs. Press firmly to adhere.
4
Insert Cam Bolts
1
into the 3 indicated holes on
the Right Side
C
.
Apply Foot Pads
?
to the bottom of the Right
Side legs. Press firmly to adhere.
Hardware Required:
1
Cam Bolt x3
?
Foot Pad x2
C
1
