Notes:
(1). Make sure outside sensor and weather station main unit at the same
channel.
(2). Do not touch any buttons in the 3 MINUTES to avoid sensor searching
be terminated.
(3). The main unit will automatically receive sensor’s RF signal in 3
MINUTES after it powered on. During receiving ,signal icon will
flashing, if no signal received within 3 minutes, it will stop receiving, and
you can press and hold the
“CH/▲” Button
3 seconds to receive again.
1.1. Remove the main unit’s battery compartment cover, insert 3 new AAA
batteries in the back of the display console (please take note of the battery
polarity before inserting the batteries).
3.1 POWER UP
2.Take out the metal stand inside the battery compartment and screw it
into the hole at the main unit’s backside. Install the battery compartment
cover.
3.Remove the sensor’s battery compartment cover, set the channel to
CH1
,
then insert 2 new AA batteries of sensor within 3 MINUTES.
NOTE: Prepare new and high quality alkaline batteries. Do not mix
old and new batteries. Heavy duty or rechargeable batteries are not
recommended.
3. QUICK SET-UP GUIDE
5
Note: The display will beep once and all of the LCD segments will light up
for few seconds to verify all segments are operating properly, then display
indoor temperature and humidity immediately.
