Problem
Possible Solution
10. TROUBLESHOOTING GUIDE
16
Outdoor sensor signal is
lost or showing dashes
(- -) on the display
Outdoor temperature and
humidity keeps cycling
display/how to exit the
Circular Channels Model
1.Press and hold the "CH/▲” button for 5-6 seconds to resynchronize
(Please make sure the sensor and main unit are in same channel).
2.If the the synchronization fails, bring the sensor with main unit
together and try the bellow steps:
3.Check if the sensor is out of battery and replace with new batteries.
4.The maximum transmission range is 328ft/100m, move the sensor
closer to the main unit .
5.Make sure both main unit and sensor are placed at least 3ft/0.9m
away from electronics that may interfere with the wireless communica-
tion, such as computers, TVs, microwaves, other wireless transmitters
or receivers, etc.
6.It’s much important to install the sensor properly,please refer to
REMOTE SENSOR INSTALLATION part.
“ ”cycle symbol means that main unit enter Circular Channels
Model, it will display the datas of 3 channels in order every 10
seconds.
You can press the "CH/▲” button 1-3 times to exit Circular Channels
Model and fix the channel to CH1,CH2 or CH3.
Temperature reads too
high in the daytime
Inaccurate temperature or
humidity readings
Make sure both the main unit and sensor are placed out of direct
sunlight and away from any heat sources or vents.
When the temperature/humidity is inaccurate, it is often due to the
location of the display or overpowered/under powered batteries. You
can test the accuracy at you home.
Side-by-side test: Bring the sensor in the house and place it next to the
weather station for 2 hours.
1.Temperature:Compare indoor and outdoor temperature. The
temperature should be within 4
℉
to be within tolerance.
2.Humidity:Compare indoor and outdoor humidity. The temperature
should be within 5%RH to be within tolerance.
Factory Restart:
(1).Remove all the batteries of sensor and
main unit.(2).Set the sensor channel to "CH1". (3).Insert the
batteries of main unit and press "CH/▲” button and fix the
channel to "CH1". (4).Insert the batteries of sensor,allow the
whole set device to sit together for 30 minutes to establish a
strong connection.
