BALCO HE180021, Инструкция по эксплуатации

Страница: 23 / 40

23
.
AFTER SALES SUPPORT
CUSTOMERCARE@BALCOLIFESTYLE.COM MODEL: HE180021
SETUP
Option 2 – Manually Levelling the Bed
1. Select Quick Menu on the Main Screen and select Home XYZ
NOTE: The 3D printer extruder nozzle will move to the Home position in the front left corner of the
Heated Print Bed. Turn off the 3D printer.
NOTE:
Immediately turn off the machine if any of the motors are jamming or forcing against the
chassis
2. Select Disable motor to manually move the Bed
3. Manually move the Bed so the Nozzle Head is at a corner of the Bed
4. Adjust the thumbwheels on the bottom of the Heated Print Bed so the distance between the
Bed and the Nozzle head is approximately 0.1mm apart
5. Fine tune the gap distance by sliding the levelling card or using an A4 piece of paper. You
should be able to feel a slight friction when sliding the paper between the Bed and the
Nozzle Head
6. Repeat steps 4 to 6 for all other corners of the Bed
7. Move the Extruder to the centre of the Heated Print Bed and test the gap with the levelling
card or a sheet of paper. Keep adjusting and testing until the gap is uniform on all points of
the bed