Then press
Changing Filter Cycles
5
If the preset times are inconvenient, if a different duration is preferred, or if you wish to leave the heater off during
filtering, the following procedure can be used to change the automatic filter cycle settings.
Note:
To properly clean and maintain your spa,
filtering time of at least four hours per day
(total of both cycles) is recommended.
Time of day will be shown.
“Set time” message will appear on LCD.
“Set Start Filter 1” message will appear. At this point,
each time the
is pressed, the filter start time, the
heater enable status, and the filter stop time will be
indicated on the LCD screen.
Then press
Press
Press
and the LCD will display the
current water temperature.
Press
Press
When the filter start or filter stop times
are displayed on the screen,
After entering the filter set routine,
you must
to reset the times.
Or
Press
When the “set heat” message is displayed,
To exit the filter set routine
to set the center display to “on” or “off.”
In the “on” position, the spa will warm to the set
temperature during the filter cycles. In the “off”
position, the heater, in the economy mode, will not be
activated during the filter cycles.
Or
to proceed through all the start and stop times for both
filter cycles. Just follow the same procedure to adjust the
“Filter 2” settings.
