11
Setting the Time
Once the spa has been properly connected, notice the “set time” message flashing on the screen.
Press
Then
Then
Press
to exit the “set time” procedure.
Or
After either pad is pressed once, hours will advance or decrease automatically in one-minute increments.
Press either pad again to stop the display’s time-setting cycle.
Panel Lock
Press
within 3 seconds. When locked, the display will show the temperature you have chosen, along with the
“lock” symbol. All pads are frozen except the
pad.
Panel Unlock
Press
within 2 seconds. The lock symbol will disappear and all panel pads will work again.
Optional Filter Cycle
Programming
While you are not required to set filter cycles, if you
want to change them, press
within 3
seconds. “SET START FILTER 1” (AM cycle) will
appear on the display.
Press
or
to reset the filter start time.
When “SET HEAT” is on the display, press
“on”
to warm the water during filtering, or press
“off”
to disable the heater.
Press
to see “SET STOP FILTER 1” and adjust
the time with the
or
as done above.
Press
to see “SET START FILTER 2” (PM cycle)
and proceed as above.
Pressing
will enter the new filter cycle times into
the system and display the current water temperature.
