BALAY 3VS950IA, Инструкция по эксплуатации

Страница: 18 / 30

en
18
Switching off the appliance
Short time after the end of the programme:
Open the door.
Switch off ON/OFF switch
1
.
Turn off the tap (not applicable
if Aqua-Stop fitted).
Remove the utensils when they have
cooled down.
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
Interrupting the programme
Open the door.
Switch off ON/OFF switch
1
.
The LEDs go out. The programme
is saved.
If the door was opened on an appliance
which has a warm water connection
or is heated, first leave the door ajar
for several minutes and then close.
Otherwise, expansion (pressure) may
cause the appliance door to spring
open or water to run out of the
appliance.
To continue the programme, switch
on the ON/OFF switch
1
again.
Close the door.
Terminating the programme
(Reset)
Open the door.
Press START button
10
for
approx 3 sec. is indicated
on the digital display
3
.
Close the door.
The programme sequence lasts
approx. 1 min.
is indicated on the digital
display
3
(buzzer sounds).
Open the door.
Switch off ON/OFF switch
1
.
Close the door.
Changing the programme
When the START button
10
has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme (reset).
Intensive drying
The final rinse uses a higher temperature
which improves the drying result.
The running time may increase slightly.
(Caution if utensils are delicate!)
Open the door.
Switch on ON/OFF switch
1
.
Hold down programme button A
and press START button
10
until on
the digital display is indicated.
Release both buttons.
The LED for button A flashes and
the digital display displays the factory
setting
.
Press programme button A until the
factory set value
is indicated on
the digital display
3
.
To change the setting,
Press the button C to switch
intensive drying on
or off .
Press START button
10
.
The set value is saved.
Close the door.