en
21
The majority of faults which could occur in
daily operation can be rectified by the
user. This ensures that the appliance is
quickly available for use again. The
following overview will help you locating
the causes and gives helpful advise to
eliminate them.
Note
If the appliance stops during dishwashing
for no obvious reason, first run the Abort
programme function (Reset).
(See chapter entitled “Dishwashing”)
ã=
Warning
If on the digital display
8
an error code
(
“
:
‹‚
to
“
:
„‹
)
, always disconnect the
appliance from the power supply and then
turn off the tap.
You can rectify certain faults yourself (see
following fault description), for all other
faults please contact customer service and
state the indicated fault
“
:XX.
ã=
Warning
Don’t forget: Repairs may be carried out
by technicians only. If a component has to
be replaced, ensure that only original
spare parts are used. Improper repairs or
use of non-original spare parts may cause
considerable damage and put the user at
considerable risk.
Waste water pump
Large food remnants in the rinsing water
not retained by the filters may block the
waste water pump. The rinsing water is
then not pumped out and covers the filter.
In this case:
–
First disconnect the appliance from the
power supply.
–
Remove the filters
1Z
.
–
Scoop out water, use a sponge if
required.
–
Using a spoon, prise off pump cover
(as illustrated) until it clicks, then grip
the cover by the lug and first pull it
upwards until it resists and then pull it
out forwards.
–
Check inner compartment and remove
any foreign objects.
–
Place cover in the original position,
press down and engage.
–
Install filters.
Troubleshooting
1
2
3
Klick
