BALAY 3VS300BA, Инструкция по эксплуатации

Страница: 24 / 28

en
24
Electrical connection
Connect the appliance to an alternating
current only, ranging from 220 V to
240 V and 50 Hz or 60 Hz via a correctly
installed socket with protective earth
conductor. See rating plate for required
fusing
32
.
The socket must be near the appliance
and freely accessible following
installation.
The connection may be modified
by technicians only.
A power cord extension may be
purchased from customer service only.
Use only a residual-current-operated
circuit-breaker which features the
symbol. Only this extension guarantees
compliance with the currently valid
regulations.
The appliance features a water damage
protection system. Please note the
system will function only when the
power supply is connected.
Removing the appliance
Also observe the sequence of worksteps
here.
Disconnect the appliance from
the power supply.
Turn off the water supply.
Disconnect the waste water and fresh
water connections.
Loosen the fastening screws under
the worktop.
If fitted, remove the base panel.
Pull out the appliance, carefully pulling
the hose behind.
Transportation
Empty the dishwasher and secure
loose parts.
Drain the appliance according to the
following steps:
Turn on the tap.
Close the door.
Switch on ON/OFF switch
1
.
Select programme with the highest
temperature.
Press Start button
4
.
Programme sequence starts.
After approx. 4 minutes press
the Start button
4
until the
Cleaning display
11
goes out.
After approx. 1 min. the End
display
10
is lit.
Switch the appliance off
1
and turn the tap off.
Transport appliance upright only.
(This prevents residual water from
running into the machine control and
damaging the programme sequence.)
Protection against frost
If the appliance is in a room where there
is a risk of frost (e.g. holiday home),
empty the appliance completely
(see Transportation).
Turn off the tap, disconnect supply hose
and drain water.