ATTACH TUBES TO CURVED TOP PIECE
Slide the Pole System tubes
into the curved Pole System
top. With the tubes properly
aligned as completed above,
slide the end with the welded
smaller tube into the top piece.
Make sure the weld nut on
curved top is facing up. Insert
the set screw (located in your
hardware package) and tighten
using the provided hex key.
ATTACH TUBES TO BASE PLATE
In your hardware package,
locate the two flat-head bolts.
Also, locate the Wall Tower
base plate. Thread the bolts
through the holes in the base
plate to secure the bottom of
the tubes. Tighten the bolts
using the hex key. Make sure
the eyebolts in the base plate
are facing up.
INSTALL EYE BOLTS INTO TUBES
Install eye bolts into the
large/small holes that are
perpendicular to the floor. For
each hole, screw an eye bolt
into the small hole in the side
of the tube. The small black
metal disk (looks like the brim
of a cowboy hat) fits over the
end of the bolt on the side
with the large hole (side that
would face the wall when Wall
Tower is upright).
Screw the cap nut onto the eye bolt, flush with the disk. DO NOT
overtighten the screws – this can damage the parts.
Note:
attach the push-through bar AFTER you have secured the Tower
to the wall and floor.
SECURE THE WALL TOWER TO THE WALL
The curved top piece is
designed to screw into the
studs at standard 16” spacing.
(If you do not have the
standard spacing or if you
need to have the Wall Tower
set up in a specific location
where the screw holes do not
line up with the studs, you will
need to obtain and secure a
header piece. A 2” x 4” wood
plank long enough to span
three studs will work. You can
purchase this from a hardware
or do-it-yourself store.) Use
two lag bolts to screw the Wall
Tower directly into the wall
studs or into the header which
you already screwed into the
studs.
SECURE THE WALL TOWER INTO THE FLOOR
There are two 1/4” holes in the
base plate to secure the Wall
Tower to the floor. If you have a
wood floor, you can use the
enclosed lag bolts. If you have
a concrete floor, check with
your local hardware store to
obtain the necessary hardware
and tools. YOU MUST
PROPERLY SECURE THE WALL
TOWER TO THE WALL AND
THE FLOOR.
ATTACH PUSH-THROUGH BAR
Place the bar between the
tubes, aligned with the holes
you wish to use. Insert the
T-pins from the outside of
the tubes by depressing the
button.
3
