ASSEMBLE THE POLE SYSTEM
LAY OUT ALL THE PARTS.
1. Make sure you have all the components listed in the parts list.
Also make sure you have acquired the hardware necessary to
attach the equipment to your wall.
ATTACHING TUBES TO THE CURVED TOP PIECE
2. Make sure there is enough
room to lay the entire system
on the floor without hitting
any furniture in the room.
Remove the tube assembly
from the shipping box. Lay
the tube assembly on the
floor so the riv nuts face
down on the floor. See Figure
C. Place the curved piece on
the open end of the tubes by
sliding the welded ends into the curved top piece. See Figure
D for orientation and locations of set screws. Insert the set
screws (located in your hardware package) and tighten using
the provided hex key.
SECURE THE POLE SYSTEM TO THE WALL
3. Secure the Pole System
to your wall using the
appropriate method. See
Important Installation Note
on page 1.
SECURE THE POLE SYSTEM INTO THE FLOOR
4. There are two 1/4” holes in
the base plate to secure the
Pole System to the floor.
See Figure G. If you have a
wood floor, you can use the
enclosed lag bolts. If you
have a concrete floor, check
with your local hardware
store or contractor to obtain
the necessary hardware and
tools.
YOU MUST PROPERLY SECURE THE POLE SYSTEM TO THE
WALL
AND
THE FLOOR.
INSTALL EYE BOLTS INTO TUBES.
5. Install eyebolts and washers
into the riv nuts that are
inserted into the tubes. Using
a screwdriver and a 7/16”
wrench, tighten the eyebolts
so they are in the line with the
main tube. See Figure E.
Figure C
Figure F
Figure G
Figure E
Figure D
Set Screws
2
