10
Section 3: Set Up
Set Up: Assemble, Align And
Install Chisel Holder
Insert the small end of the quill alignment pin
(A)
into the drill chuck and tighten the chuck as shown
in
Figure 1.
Use variations combinations of two-piece and
split bushings
(B)
with the chisel holder to find
the combination that matches the diameter of the
quill.
See Figure 2
. When fitted with the right
combination, the chisel holder should fit snugly
around the quill.
NOTE:
The seams in the bushings and inserts
should align with the split in the collar of the
chisel holder.
Refer to Figure 3 for steps 3-6.
Insert the square head screw
(A)
into the collar
of the chisel holder. Fit the indexed locking handle
(B)
over the exposed threads in the screw
(Do not tighten).
Feed the thumb screw
(C)
into the threaded
hole at the bottom of the chisel holder.
Maneuver the assembled chisel holder up and
over the quill alignment pin and the quill.
The bottom of the chisel holder collar should be
flush with the bottom of the quill. Tighten the
thumb screw to secure the quill alignment pin
to the chisel holder.
Tighten the collar locking handle to secure the
chisel holder to the quill
Figure 1.
Figure 3.
Figure 2.
